EasyManuals Logo
Home>Cisco>Network Router>MWR 2941

Cisco MWR 2941 User Manual

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #410 background image
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
service (CFM-srv)
392
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
service (CFM-srv)
To configure a maintenance association within a maintenance domain and place the command-line
interface (CLI) into Ethernet connectivity fault management (CFM) service configuration mode
(config-ecfm-srv), use the service command in Ethernet CFM configuration mode. To remove the
configuration, use the no form of this command.
service {ma-name | ma-num | vlan-id vlan-id | vpn-id vpn-id} [port | vlan vlan-id
[direction down]]
no service {ma-name | ma-num | vlan-id vlan-id | vpn-id vpn-id} [port | vlan vlan-id
[direction down]]
Syntax Description
Command Default No maintenance associations are configured.
Command Modes Ethernet CFM configuration (config-ecfm)
Command History
Usage Guidelines The maintenance association ID (MAID) is a combination of a maintenance domain ID and the short
maintenance association name, and the length of the MAID TLV should not exceed 48 characters.
If you configure the same short maintenance association name for two VLANs in the same domain, an
error message is displayed and the command is rejected.
ma-name Short maintenance association name.
ma-num Integer from 0 to 65535 that identifies the maintenance association.
vlan-id Configures a primary VLAN.
vlan-id Integer from 1 to 4094 that identifies the primary VLAN.
vpn-id Configures a virtual private network (VPN).
vpn-id Integer from 1 to 32767 that identifies the VPN.
port (Optional) Configures a DOWN service direction without a VLAN
association.
vlan (Optional) Configures a VLAN.
direction (Optional) Configures the service direction. The default is “up.
down (Optional) Configures the direction toward the LAN.
Release Modification
12.2(33)SXI2 This command was introduced.
12.2(33)SRE This command was integrated into Cisco IOS Release 12.2(33)SRE.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
releaes does not support the vpn-id keyword.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MWR 2941 and is the answer not in the manual?

Cisco MWR 2941 Specifications

General IconGeneral
BrandCisco
ModelMWR 2941
CategoryNetwork Router
LanguageEnglish

Related product manuals