Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
dejitter-buffer
98
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
dejitter-buffer
To configure the size of the dejitter buffer, use the dejitter-buffer command in CEM configuration mode.
To restore the dejitter buffer to its default size, use the no form of this command.
dejitter-buffer size
no dejitter-buffer
Syntax Description
Defaults The default dejitter-buffer size is 4 milliseconds.
Command Modes CEM configuration
Command History
Examples The following example shows how to specify the size of the dejitter buffer:
Router# config t
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# dejitter-buffer 10
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands
size Specifies the size of the dejitter buffer in milliseconds. The range is 4 to 500
ms; the default is 4 ms.
Release Modification
12.3(7)T This command was introduced.
12.4(19)MR2 This command was integrated into Cisco IOS Release 12.4(19)MR2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
cem Enters circuit emulation configuration mode.
cem class Applies the CEM interface parameters defined in the given CEM
class name to the circuit.
class cem Configures CEM interface parameters in a class that’s applied to
CEM interfaces together in global configuration mode.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English