Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show link-protection statistics
551
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
show link-protection statistics
To display the counters for each link protection port, use the show link-protection statistics command
in user EXEC or privileged EXEC mode.
show link-protection statistics [interface interface-name slot/port]
Syntax Description
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Usage Guidelines This command only applies to Gigabit Ethernet interfaces.
Use this command to configure Microwave 1+1 Hot Standby Protocol (HSBY). For more information
about HSBY, see the Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide,
Release 15.0(1)MR.
Examples The following examples provide sample output from the show link-protection statistics command:
Router# show link-protection statistics
Counters:
---------
Port: Gi0/1
Group: 1
TLV Rx: 683
TLV Tx: 685
TLV Rx: 0
Invalid TLV Rx: 0
Sender OK Rx: 0
Sender KO Rx: 0
Suspend Flag Rx: 0
ODU Failure: 1
Port: Gi0/2
Group: 1
TLV Rx: 680
TLV Tx: 698
Invalid TLV Rx: 0
Sender OK Rx: 0
Sender KO Rx: 0
Suspend Flag Rx: 0
ODU Failure: 1
interface Specifies the interface connected to the clock input.
interface-name The name of the interface connected to the clock input.
slot The slot in which card is inserted.
port The port of the card.
Release Modification
15.0(1)MR This command was introduced.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English