Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
recovered-clock recovered
363
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
recovered-clock recovered
The recovered-clock recovered command allows you to configure in-band pseudowire-based active
clock recovery on a CEM interface. To disable this feature, use the feature, use the no form of this
command.
recovered-clock recovered adaptive cem subslot-number port-number cem-group-number
no recovered-clock recovered adaptive cem subslot-number port-number cem-group-number
Syntax Description
Defaults There is no default setting.
Command Modes Global configuration
Command History
Usage Guidelines For more information about adaptive clock recovery, see the Cisco MWR 2941-DC Mobile Wireless
Edge Router Software Configuration Guide.
Examples The following example shows how to use the recovered-clock recovered command:
Router# config t
Router(config)# recovered-clock recovered adaptive cem 0 0 0
Router(config)# exit
Related Commands
adaptive Specifies the clock recovery type.
cem Specifies the Circuit emulation (CEM) interface for the recovered clock.
subslot-number The subslot of the CEM interface for the recovered clock.
port-number The port number of the CEM interface for the recovered clock.
cem-group-number The CEM group to which the clock applies.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
recovered-clock slave Allows you to configure out-of-band clock recovery,

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English