Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
preferred-path
319
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
preferred-path
Specifies the preferred path within an MPLS pseudowire-class where multiple paths exist. To remove a
preferred path, use the no form of this command.
preferred-path {[interface] tunnel tunnel] | peer peer} disable-fallback
no preferred-path {[interface] tunnel tunnel] | peer peer} disable-fallback
Syntax Description
Command Default This command is disabled by default.
Command Modes Pseudowire class configuration
Command History
Examples The following example creates a pseudowire class called pw_tun2, specifies MPLS encapsulation, and
specifies a preferred path with fallback disabled.
Router# configure terminal
Router(config)# pseudowire-class pw_tun2
Router(config-pw-class)# encapsulation mpls
Router(config-pw-class)# preferred-path peer 50.0.0.2 disable-fallback
interface Specifies the preferred path using an output interface.
tunnel Specifies a tunnel interface.
tunnel The tunnel interface number.
peer Specifies the preferred path using a peer host name or IP address.
peer The peer host name or IP address.
disable-fallback Specifies that pseudowire class traffic cannot use an alternate route.
Release Modification
12.0(25)S This command was introduced.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English