Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
controller shdsl
95
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
controller shdsl
To configure a controller for single-pair high-bit-rate digital subscriber line (SHDSL) mode, use the
controller shdsl command in global or controller configuration mode.
controller shdsl slot-number/subslot-number/port-number
Syntax Description
Defaults Controller number: 0
Command Modes
Cisco HWIC-4SHDSL
Global configuration
Controller configuration
Command History
Usage Guidelines This command is used to configure the controller mode and the controller number.
Examples
Cisco HWIC-4SHDSL
The following example uses the controller shdsl command to configure a Cisco HWIC-4SHDSL
installed in a Cisco access router, controller number 0, subslot 2, port number 0); the example enters
controller configuration mode:
Router(config)# controller shdsl 0/2/0
Router(config-controller)#
number Controller number. The valid controller number is 0.
slot-number/ Defines the slot on the router in which the high-speed WAN interface cards
(HWIC) is installed.
subslot-number/ Defines the subslot on the router in which the HWIC is installed.
port-number Defines the port on the router in which the HWIC is installed. By default,
Cisco HWIC-4SHDSL and HWIC-2SHDSL use port number 0.
Release Modification
11.3(5)AAA This command was introduced.
12.2(8)T This command was implemented on Cisco IAD2420 series IADs.
12.4(15)T This command was introduced for the Cisco HWIC-4SHDSL and
HWIC-2SHDSL running on the Cisco 1841 router, and on the Cisco 2800
and 3800 series access routers.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English