Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
set cos-inner
408
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
set cos-inner
To mark the inner class of service field in a bridged frame, use the set cos-inner command in policy-map
class configuration mode. To remove marking of the inner CoS field, use the no form of this command.
set cos-inner cos-value
no set cos-inner cos-value
Syntax Description
Defaults No default behavior or values.
Command Modes Policy-map class configuration
Command History
Usage Guidelines This command was introduced in Cisco IOS Release 12.2(33)SRA to support marking of the inner CoS
value when using multipoint bridging (MPB) features on the Enhanced FlexWAN module, and when
using MPB features on SPAs with the Cisco 7600 SIP-200 and Cisco 7600 SIP-400 on the Cisco 7600
series router.
This command is not supported on the Cisco 7600 SIP-600.
On the Cisco 7600 SIP-200, this command is not supported with the set cos command on the same
interface.
For more information about QoS and the forms of marking commands supported by the SIPs on the
Cisco 7600 series router, refer to the Cisco 7600 Series SIP, SSC, and SPA Software Configuration
Guide.
Examples The following example shows configuration of a QoS class that filters all traffic matching on VLAN 100
into a class named “vlan-inner-100.” The configuration shows the definition of a policy-map (also
named “vlan-inner-100”) that marks the inner CoS with a value of 3 for traffic in the vlan-inner-100
class. Since marking of the inner CoS value is only supported with bridging features, the configuration
also shows the service policy being applied as an output policy to a serial SPA interface that bridges
traffic into VLAN 100 using the bridge-domain command:
Router(config)# class-map match-all vlan-inner-100
Router(config-cmap)# match vlan inner 100
Router(config-cmap)# exit
cos-value IEEE 802.1q CoS value from 0–7.
Release Modification
12.2(33)SRA This command was introduced.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English