Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ptp mode
346
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ptp mode
To specify the transport mode for Precision Time Protocol (PTP), use the ptp mode command in global
configuration mode. To remove a PTP mode configuration, use the no form of this command.
ptp mode [ordinary | boundary]
no ptp mode [ordinary | boundary]
Note The Cisco MWR 2941 does not currently support other PTP transport modes.
Syntax Description
Defaults The default setting is ptp mode ordinary.
Command Modes Global configuration
Command History
Usage Guidelines For more information about configuring PTP, see the Cisco MWR 2941-DC Mobile Wireless Edge
Router Software Configuration Guide.
Examples The following example shows how to enable ptp mode:
Router# config t
Router(config)# ptp mode ordinary
Router(config)# exit
Related Commands
ordinary Sets the router to act as a PTP ordinary clock.
boundary Sets the router to act as a PTP boundary clock.
Release Modification
12.4(19)MR2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
15.0(2)MR Support for the boundary parameter was added.
Command Description
ptp enable Enables PTP mode on an interface.
ptp master Sets an interface in master clock mode for PTP clocking
ptp slave Sets an interface to slave clock mode for PTP clocking.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English