Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
set dscp
414
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
set dscp
To mark a packet by setting the differentiated services code point (DSCP) value in the type of service
(ToS) byte, use the set dscp command in policy-map class configuration mode. To remove a previously
set DSCP value, use the no form of this command.
set [ip] dscp {dscp-value}
no set [ip] dscp {dscp-value}
Syntax Description
Command Default Disabled
Command Modes Policy-map class configuration
Command History
ip (Optional) Specifies that the match is for IPv4 packets only. If not used, the
match is on both IPv4 and IPv6 packets.
dscp-value A number from 0 to 63 that sets the DSCP value. The following reserved
keywords can be specified instead of numeric values:
• EF (expedited forwarding)
• AF11 (assured forwarding class AF11)
• AF12 (assured forwarding class AF12)
Release Modification
12.2(13)T This command was introduced. It replaces the set ip dscp command.
12.0(28)S Support for this command in IPv6 was added on the in Cisco IOS
Release 12.0(28)S
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR. This
release does not support the from-field and table options.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA. This
release does not support the from-field and table options.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support Weighted Random Early Detection (WRED).

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English