Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
rep lsl-retries
370
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
rep lsl-retries
To configure the Resilient Ethernet Protocol (REP) link status layer (LSL) number of retries, use the
rep lsl-retries command in interface configuration mode. To restore the default number of retries, use
the no form of this command.
rep lsl-retries number-of-retries
no rep lsl-retries number-of-retries
Syntax Description
Command Default The default number of retries is 5.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines REP is a Cisco proprietary protocol that provides functionality to:
• Control network loops
• Handle link failures
• Improve convergence time
The rep lsl-retries command is used to configure the number of retries before the REP link is disabled.
Examples This example shows how to configure REP link status layer number of retries.
Router# enable
Router# configure terminal
Router(config)# interface gigabitethernet 2/5
Router(config-if)# rep segment 2 edge primary
Router(config-if)# rep lsl-retries 4
Router(config-if)# exit
Related Commands
number-of-retries Specifies the number of LSL retries. The acceptable range is between 3 and
10 retries. The default number of retries is 5.
Release Modification
15.0(1)S This command was introduced on the Cisco 7600 series routers.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
rep lsl-age-timer Configures the REP link status layer age-out timer value.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English