Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm global
119
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ethernet cfm global
To enable Ethernet connectivity fault management (CFM) globally on a device, use the ethernet cfm
global command in global configuration mode. To disable CFM globally on a device, use the no form
of this command.
ethernet cfm global
no ethernet cfm global
Syntax Description This command has no arguments or keywords.
Command Default Ethernet CFM is disabled.
Command Modes Global configuration (config)
Command History
Usage Guidelines Ethernet CFM is disabled by default and must be enabled explicitly. When CFM is configured, hardware
resources (for example, port-ASIC match registers) are allocated for CFM.
This command is supported only in the Ethernet CFM IEEE 802.1ag Standard implementation.
Examples The following example shows how to enable CFM globally on a device:
Router(config)# ethernet cfm global
Related Commands
Release Modification
12.2(33)SXI2 This command was introduced.
12.2(33)SRE This command was integrated into Cisco IOS Release 12.2(33)SRE.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Command Description
ethernet cfm ieee Enables the Ethernet Connectivity Fault Management 802.1ag
Standard (CFM IEEE) version of CFM.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English