Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
ethernet cfm logging
122
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
ethernet cfm logging
To enable Ethernet Connectivity Fault Management (CFM) syslog messages, use the ethernet cfm
logging command in global configuration mode. To disable CFM syslog messages, use the no form of
this command.
CFM IEEE 802.1ag Standard (CFM IEEE)
ethernet cfm logging [ais | alarm {cisco | ieee} | lck]
no ethernet cfm logging [ais | alarm {cisco | ieee} | lck]
Syntax Description
Command Default CFM logging is not enabled.
Command Modes Global configuration (config)
Command History
Examples The following example shows how to enable all Ethernet CFM syslog messages:
Router(config)# ethernet cfm logging
The following example shows how to enable all alarm syslog messages for Cisco MIBs:
Router(config)# ethernet cfm logging alarm cisco
The following example shows how to enable syslog messages specific to the CFM AIS feature:
Router(config)# ethernet cfm logging ais
ais (Optional) Enables syslog messages specific to the CFM Alarm Indication
Signal (AIS) feature.
alarm (Optional) Specifies an alarm.
cisco (Optional) Enables alarm syslog messages for Cisco MIBs.
ieee (Optional) Enables alarm syslog messages for IEEE MIBs for all VLAN
services.
lck (Optional) Enables syslog messages specific to the CFM Locked Signal
function (LCK).
Release Modification
12.2(33)SRD This command was introduced.
12.2(33)SXI2 This command was integrated into Cisco IOS Release 12.2(33)SXI2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the Cisco pre-standard CFM Draft 1 (CFM D1).

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English