EasyManuals Logo

Cisco MWR 2941 User Manual

Cisco MWR 2941
708 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #315 background imageLoading...
Page #315 background image
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
police (percent)
297
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Command Default All Supported Platforms
The default bc and be values are 4 ms.
Command Modes Policy-map class configuration (config-pmap-c)
violate-action (Optional) Action to take on packets whose rate exceeds the conform plus
exceed burst. You must specify the exceed-action before you specify the
violate-action.
action (Optional) Action to take on packets. Specify one of the following keywords:
All Supported Platforms
• drop—Drops the packet.
• set-clp-transmit—Sets the ATM Cell Loss Priority (CLP) bit from 0
to 1 on the ATM cell and sends the packet with the ATM CLP bit set
to 1.
• set-dscp-transmit new-dscp—Sets the IP differentiated services code
point (DSCP) value and sends the packet with the new IP DSCP value
setting.
• set-frde-transmit—Sets the Frame Relay discard eligible (DE) bit from
0 to 1 on the Frame Relay frame and sends the packet with the DE bit
set to 1.
• set-prec-transmit new-prec—Sets the IP precedence and sends the
packet with the new IP precedence value setting.
• transmit—Sends the packet with no alteration.
Supported Platforms Except the Cisco 10000 Series Router
• policed-dscp-transmit—(Exceed and violate action only). Changes the
DSCP value per the policed DSCP map and sends the packet.
• set-cos-inner-transmit value—Sets the inner class of service field as a
policing action for a bridged frame on the Enhanced FlexWAN module,
and when using bridging features on SPAs with the Cisco 7600 SIP-200
and Cisco 7600 SIP-400 on the Cisco 7600 series router.
• set-cos-transmit value—Sets the packet cost of service (CoS) value and
sends the packet.
• set-mpls-exposition-transmit—Sets the Multiprotocol Label
Switching (MPLS) experimental bits from 0 to 7 and sends the packet
with the new MPLS experimental bit value setting.
• set-mpls-topmost-transmit—Sets the MPLS experimental bits on the
topmost label and sends the packet.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MWR 2941 and is the answer not in the manual?

Cisco MWR 2941 Specifications

General IconGeneral
BrandCisco
ModelMWR 2941
CategoryNetwork Router
LanguageEnglish

Related product manuals