Cisco MWR 2941 User Manual

Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
show interface rep
534
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01
Examples This is sample output from the show interface rep command:
Switch # show interface rep
Interface Seg-id Type LinkOp Role
---------------------- ------ ------------ ----------- ----
GigabitEthernet 0/1 1 Primary Edge TWO_WAY Open
GigabitEthernet 0/2 1 Edge TWO_WAY Open
FastEthernet 0/4 2 INIT_DOWN Fail
This is sample output from the show interface rep command when the edge port is configured to have
no REP neighbor. Note the asterisk (*) next to Primary Edge.
Router# show interface rep
Interface Seg-id Type LinkOp Role
---------------------- ------ -------------- ----------- ----
GigabitEthernet0/1 2 TWO_WAY Open
GigabitEthernet0/2 2 Primary Edge* TWO_WAY Open
This is sample output from the show interface rep command when external neighbors are not
configured:
Switch # show interface rep
Interface Seg-id Type LinkOp Role
---------------------- ------ ------------ ----------- ----
GigabitEthernet0/1 1 NO_NEIGHBOR FailNoNbr
GigabitEthernet0/2 2 NO_NEIGHBOR FailLogOpen
This is sample output from the show interface rep detail command for a specified interface:
Switch # show interface gigabitethernet0/2 rep detail
GigabitEthernet0/2 REP enabled
Segment-id: 1 (Segment)
PortID: 00030019E85BDD00
Preferred flag: No
Operational Link Status: INIT_DOWN
Current Key: 00000000000000000000
Port Role: Fail
Blocked VLAN: 1-4094
Admin-vlan: 1
Preempt Delay Timer: disabled
LSL Ageout Timer: 5000 ms
Configured Load-balancing Block Port: 1234567890123456
Configured Load-balancing Block VLAN: 1-4094
STCN Propagate to: none
LSL PDU rx: 0, tx: 0
HFL PDU rx: 0, tx: 0
BPA TLV rx: 0, tx: 0
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 0, tx: 0
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 0, tx: 0
Related Commands Command Description
rep segment Enables REP on an interface and assigns a segment ID. This command is also
used to configure a port as an edge port, a primary edge port, or a preferred
port.
show rep topology
[detail]
Displays information about all ports in the segment, including which one was
configured and selected as the primary edge port.

Cisco MWR 2941 Specifications

General

Brand	Cisco
Model	MWR 2941
Category	Network Router
Language	English