Configuring System Information 107
The following is an example of the CLI commands:
Defining Device IP Addresses
The IP Addressing page contains links for assigning interface and default gateway IP addresses,
and defining ARP and DHCP parameters for the interfaces.
Configuring the Internet Protocol Version 6 (IPv6)
The device functions as an IPv6 compliant Host, as well as an IPv4 Host (also known as dual stack).
This allows device operation in a pure IPv6 network as well as in a combined IPv4/IPv6 network.
The primary change from IPv4 to IPv6 is the length of network addresses. IPv6 addresses are 128 bits
long, whereas IPv4 addresses are 32 bits; allowing a much larger address space.
console> enable
console# configure
console (config) # logging 10.1.1.1 severity critical
Console# show logging
Logging is enabled.
Console Logging: Level debug. Console Messages: 5 Dropped.
Buffer Logging: Level debug. Buffer Messages: 16 Logged, 16
Displayed, 200 Max.
File Logging: Level error. File Messages: 0 Logged, 209 Dropped.
SysLog server 31.1.1.2 Logging: error. Messages: 22 Dropped.
SysLog server 5.2.2.2 Logging: info. Messages: 0 Dropped.
SysLog server 10.2.2.2 Logging: critical. Messages: 21 Dropped.
SysLog server 10.1.1.1 Logging: critical. Messages: 0 Dropped.
1 messages were not logged
03-Mar-2004 12:02:03 :%LINK-I-Up: g1
03-Mar-2004 12:02:01 :%LINK-W-Down: g2
03-Mar-2004 12:02:01 :%LINK-I-Up: g3
To Next Page
Loading...
Need help?
General
