Dell PowerConnect 5424 User Manual

272 Configuring Device Information
The following is an example of some of the CLI commands:
Defining DHCP Snooping on VLANs
The DHCP Snooping VLAN Settings Page allows network managers to enable DHCP Snooping
on VLANs. DHCP snooping separates ports in the VLAN. To enable DHCP Snooping on VLAN,
ensure that DHCP Snooping is enabled on the device.
To define DHCP snooping on VLANS, click Switch→ DHCP Snooping → VLAN Settings
Figure 7-17. VLAN Settings
• VLAN ID — The VLAN on which DHCP snooping can be enabled.
•
Enabled VLANs — Contains a list of VLANs on which DHCP snooping is enabled.
Console# show ip dhcp snooping
DHCP snooping is enabled
DHCP snooping is configured on following VLANs: 2, 7-18
DHCP snooping database: enabled
Option 82 on untrusted port is allowed
Verification of hwaddr field is enabled
Interface Trusted
----------- -----------
g1 yes
g2 yes

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation