Dell PowerConnect 5424 User Manual

Configuring System Information 239
Defining iSCSI Sessions Using CLI Commands
The following table summarizes the equivalent CLI commands for defining fields displayed in the iSCSI
Sessions page.
The following is an example of the CLI commands:
Figure 6-112. iSCSI Sessions CLI Commands
CLI Command Description
show iscsi sessions
[
detailed ]
To display the iSCSI sessions, use the show iscsi sessions
privileged EXEC command.
Console# show iscsi sessions
iSCSI enabled
iSCSI vpt: 5, remark
Session aging time: 60 min
Maximum number of sessions: 256
iSCSI targets and TCP ports:
---------------------------
TCP Target IP Name
Port Address
----- --------- ----
860
3260
5000
30001 172.16.1.1 iqn.1993-11.com.disk-
vendor:diskarrays.sn.45678.tape:sys1.xyz
30033 172.16.1.10
30033 172.16.1.25

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation