Dell PowerConnect 5424 User Manual

Hardware Description 27
If both RJ-45 and SFP are present, and a connector is inserted in the SFP port, the SFP port is active,
unless the copper connector of the Base-T port of the same number is inserted and has a link.
The system can switch from the RJ-45 to the SFP (or vice-versa) without a system reboot or reset.
Physical Dimensions
The device has the following physical dimensions:
• Height — 44 mm (1.73 inch)
• Width — 440 mm (17.32 inch)
• Depth — 255 mm (10.03 inch)
LED Definitions
The front panel contains light emitting diodes (LED) that indicate the status of links, power supplies,
fans, and system diagnostics.
Port LEDs
10/100/1000 Base-T Port LEDs
Each 10/100/1000 Base-T port has two LEDs. Speed/link/activity is indicated on the left LED and the
duplex mode is indicated on the right LED.
Figure 2-4. RJ-45 Copper based 10/100/1000 BaseT LEDs
The RJ-45 LED indications are described in the following table:
Table 2-1. RJ-45 Copper based 10/100/1000BaseT LED Indications
LED Color Description
Left LED Green Static The port is linked at 1000 Mbps.
Green Flashing The port is transmitting or receiving data at 1000 Mbps.
Orange Static The port is linked at either 10 or 100 Mbps.
Orange Flashing The port is transmitting or receiving data at either 10 or 100 Mbps.
Right LED Green The port is currently transmitting in Full Duplex mode.
OFF The port is operating in Half Duplex mode.

Dell PowerConnect 5424 Specifications

General

Brand	Dell
Model	PowerConnect 5424
Category	Switch
Language	English