Dell PowerConnect 5424 User Manual

Configuring System Information 113
Defining DHCP IPv4 Interface Parameters
The DHCP IPv4 Interface page contains fields for specifying the DHCP clients on device interfaces.
Click System→ IP Addressing→ DHCP IPv4 Interface in the tree view. To open the DHCP IPv4
Interface page.
Figure 6-26. DHCP IPv4 Interface
• Interface — The specific interface on which the DHCP client is configured. Click the option button
next to
Port , LAG , or VLAN and select the interface connected to the device.
•
Host Name — The system name as it is defined on the DHCP server (up to 20 characters).
•
Remove — When selected, removes DHCP clients.
Adding DHCP Clients
1 Open the DHCP IPv4 Interface page.
2 Click Add .
The
Add DHCP IPv4 Interface page opens.
3 Complete the information on the page.
4 Click Apply Changes .
The DHCP Interface is added, and the device is updated.

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation