Configuring System Information 231
Configuring General Device Tuning Parameters
The General Settings page provides information for defining general device parameters. To open the
General Settings page, click System
→ Advanced Settings → General in the tree view.
Figure 6-104. General Settings
•
Attribute
— The general setting attribute.
•
Current
— The currently configured value.
•
After Reset
— The future (after reset) value. By entering a value in the After Reset column, memory is
allocated to the field table.
•
Max RAM Log Entries (20-400)
— The maximum number of RAM Log entries. When the Log
entries are full, the log is cleared and the Log file is restarted.
•
Jumbo Frames
— Enables or disables the Jumbo Frames feature. Jumbo Frames enable the
transportation of identical data in fewer frames. This ensures less overhead, lower processing time, and
fewer interrupts.
•
Switch Mode
— Specifies the device working mode. The new mode becomes active only after device
reset. The possible field values are:
–
ACL & iSCSI
— The devices uses Access Control Lists and iSCSI. Dynamic VLAN Assignment is
not used. For more information see "ACL Overview" on page 256 and "Optimizing iSCSI" on
page 232.
–
DVA & iSCSI
— The device uses Dynamic VLAN Assignment and iSCSI. Accesss Control Lists
are not used. For more information see "Configuring Advanced Port Based Authentication" on
page 248 and "Optimizing iSCSI" on page 232.
To Next Page
Loading...
Need help?
General
