Dell PowerConnect 5424 User Manual

Configuring System Information 115
Defining IPv6 Interfaces
The system supports IPv6 hosts. The IPv6 Interface page contains fields for defining IPv6 interfaces.
To open the IPv6 Interface page, click System
→ IP Addressing→ IPv6 Interface in the tree view.
Figure 6-27. IPv6 Interface
• Interface — The IPv6 interface that has been selected for configuration.
•
Remove — When selected, removes the IPv6 attributes of the interface.
•
DAD Attempts — Defines the number of consecutive neighbor solicitation messages that are sent on
an interface while Duplicate Address Detection (DAD) is performed on unicast IPv6 addresses on this
interface. New addresses remain in a tentative state while duplicate address detection is performed.
A field value of 0, disables duplicate address detection processing on the specified interface. A field
value of 1, indicates a single transmission without follow up transmissions. Range is 0-600, default is 1.

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation