Configuring System Information 147
The following is an example of the CLI command:
Managing Device Security
The Management Security page provides access to security pages that contain fields for setting security
parameters for ports, device management methods, user, and server security. To open the Management
Security page, click System→Management Security in the tree view.
Defining Access Profiles
The Access Profiles page contains fields for defining profiles and rules for accessing the device. Access to
management functions can be limited to user groups, which are defined by ingress interfaces and source
IP address and/or source IP subnets.
Management access can be separately defined for each type of management access method, including,
Web (HTTP), Secure web (HTTPS), Telnet, Secure Telnet and SNMP.
Access to different management methods may differ between user groups. For example, User Group 1
can access the device only via an HTTPS session, while User Group 2 can access the device via both
HTTPS and Telnet sessions.
console> enable
Console# show fiber-ports optical-transceiver
Power
Port Temp
(C)
Voltage
(Volt)
Current
(mA)
Output
(mWatt)
Input
(mWatt)
TX
Fault
LOS
21 W OK OK OK OK OK OK
22 OK OK OK OK OK E OK
23 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
To Next Page
Loading...
Need help?
General
