Dell PowerConnect 5424 User Manual

334 Configuring Device Information
Defining VLAN LAG Settings
The VLAN LAG Setting page provides parameters for managing LAGs that are part of a VLAN.
VLANs can either be composed of individual ports or of LAGs. Untagged packets entering the device are
tagged with the LAGs ID specified by the PVID. To open the VLAN LAG Setting page, click Switch→
VLAN→ LAG Settings in the tree view.
Figure 7-44. VLAN LAG Setting
• LAG — The LAG number included in the VLAN.
•
LAG VLAN Mode — The LAG VLAN mode. Possible values are:
–
General — The LAG belongs to VLANs, and each VLAN is user-defined as tagged or untagged
(full 802.1Q mode).
–
Access — The LAG belongs to a single, untagged VLAN.
–
Trunk — The LAG belongs to VLANs in which all ports are tagged (except for an optional single
native VLAN).
•
PVID — Assigns a VLAN ID to untagged packets. The possible field values are 1-4095. VLAN 4095 is
defined as per standard and industry practice, as the discard VLAN. Packets classified to this VLAN are
dropped.
•
Frame Type — Packet type accepted by the LAG. Possible values are:
–
Admit Tag Only — Only tagged packets are accepted by the LAG.
–
Admit All — Tagged and untagged packets are both accepted by the LAG.

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation