Name: Epson AcuLaser CX17 Series
Brand: Epson
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Chapter 4

Printer Connection and Software Installation

Overview of Network Setup and Configuration (Epson AcuLaser CX17NF/

CX17WF Only)

To set up and configure the network:

1. Connect the printer to the network using the recommended hardware and cables.

2. Turn on the printer and the computer.

3. Print the System Settings page and keep it for referencing network settings.

4. Install the driver software on the computer from the Software Disc. For information on driver

installation, see the section in this chapter for the specific operating system you are using.

5. Configure the printer’s TCP/IP address, which is required to identify the printer on the network.

❏ Microsoft

Windows

operating systems: Run the Installer on the Software Disc to

automatically set the printer’s Internet Protocol (IP) address if you connect the printer to an

established TCP/IP network. You can also manually set the printer’s IP address on the

operator panel.

❏ Mac OS

X systems: Manually set the printer’s TCP/IP address on the operator panel. To use a

wireless connection, also configure wireless settings on the operator panel. (A wireless

connection is available only on the Epson AcuLaser CX17WF.)

6. Print a System Settings page to verify the new settings.

Note:

The reports and lists are all printed in English.

Epson AcuLaser CX17 Series User Manual

Other manuals for Epson AcuLaser CX17 Series