Item Specification
Security 64 (40-bit key)/ 128 (104- bit key) WEP, WPA- PSK (TKIP, AES), WPA2-PSK (AES)
(IEEE802.1x attestation function of WPA 1x non-corresponds)
Certifications Wi-Fi, WPA2.0 (Personal)
Wi-Fi Protected Setup (WPS) Push Button Configuration (PBC), Personal Identification Number (PIN)
You can select a method to configure a wireless setting from the following:
Wizard Setup Through USB Connection
Advanced Setup Through
Ethernet connection
Operator Panel
EpsonNet Config
WPS-PIN
*1
WPS-PBC
*2
*1
WPS-PIN (Wi-Fi
®
Protected Setup-Personal Identification Number) is a method to authenticate and register devices
required for wireless configuration, by entering PIN code in the printer and computer. This setting, performed through
access point, is available only when the access points of your wireless router supports WPS.
*2
WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required for
wireless configuration, by pressing the button provided on the access point via wireless routers, and then performing
WPS-PBC setting on the operator panel. This setting is available only when the access point supports WPS.
Using Wizard Setup to Configure Wireless Settings
The following procedure uses Windows XP as an example.
1. Insert the Software Disc into your computer’s CD/DVD drive.
The Install Navi launches.
Note:
If the Software Disc does not automatically launch, click Start (start for Windows XP) — All
Programs (for Windows Vista and Windows 7) — Accessories (for Windows Vista and Windows
7) — Run, and then enter D:\EPSetup.exe (where D is the drive letter of your computer’s CD/DVD
drive), and then click OK.
2. Click Easy Install.
Epson AcuLaser CX17 Series User’s Guide
Printer Connection and Software Installation 58
To Next Page
Loading...
Need help?
General