About Roll Paper Cutting
When performing borderless printing on roll paper, you can specify whether to perform left and right borderless
printing or all edges borderless printing, and how to cut the paper in the printer driver's Advanced - Roll Paper
Option. The cutting operation for each value is shown in the following chart.
Printer driver
settings
Borderless Single Cut Double Cut
Cutting
Operation
Explanation
The default printer driver
setting is Borderless.
❏ The top area may become
slightly uneven depending
on the image since the
print operation stops
while cutting the top edge
of the roll paper.
❏ If the cut position is
misaligned slightly, small
parts of the image may be
shown on the top or
bottom of the adjacent
pages. If this occurs,
perform Adjust Cut
Position.
❏ When continuously
printing multiple sheets,
the printer cuts 1 mm
inside on the top edge of
the first page and the
bottom edge of the
subsequent pages to
avoid showing margins.
❏ The top area may become
slightly uneven depending
on the image since the
print operation stops
while cutting the top edge
of the roll paper.
❏ The printed paper is
approximately 2 mm
shorter than the specified
size since the printer cuts
the paper inside the image
to avoid showing top and
bottom margins.
❏ After cutting the bottom
edge of the previous page,
the printer feeds the
paper, and then cuts the
top edge of the following
page. Although this
produces 60 to 127 mm
cut-off pieces, the cut is
more accurate.
❏ If there is a margin at the
top, perform Adjust Cut
Position.
SC-P8500DM/SC-P8500D/SC-P6500D/SC-P6500DE/SC-P6500E/SC-T7700DM/SC-T5700DM/SC-T7700D/SC-T5700D/SC-3700D/SC-T3700DE/SC-T3700E/SC-P8500DL/SC-T7700DL Series User's Guide
Various Printing Methods
97
To Next Page
Loading...
Need help?
General