4.13 Printing PDF Files Directly (ContentsBridge)
92
Printing
4
4.13.2 Printing PDF Files without Using the Con-
tentsBridge Utility
You can send a PDF file directly to the printer and print the PDF file with the ipr
command without using the ContentsBridge utility. In this case, the PDF file is
printed based on the settings made for the following items:
For information about the above items, refer to "7.2.1 Print Language Setting" (P.258).
●
[Layout] is displayed when [PDF Bridge] is selected in [Print Mode].
●
When printing with the ipr command, specify the number of copies with the ipr command. The num-
ber of copies set in [Copies] on the control panel is invalid. If you do not specify the number of cop-
ies with the lpr command, 1 is assumed to be specified.
When printing a PDF file using the ipr command, you need to enable the LPD
protocol on the printer from the control panel or CentreWare Internet Services.
"1.4.1 Enabling the Port"
Supported Operating Systems
Windows NT 4.0/Windows 2000/Windows XP/Windows Server 2003
Printing PDF Files
The following a sample instruction given to the computer when printing a PDF file
with the ipr command.
A blank (space) is shown as .
Example: The [event.pdf] file is printed when the IP address of the printer is
192.168.100.
●
Print Mode
●
Password
●
Copies
●
Collate
●
2 sided
●
Paper Size
●
Print Mode
●
Layout
C:¥>ipr -P lp -S 192.168.100 event.pdf
<Enter> key
To Next Page
Loading...
Need help?
General
