[System Settings]
125
[System Settings]
[System Clock / Timers]
You can set the system clock or the time intervals of the device to reset settings.
[Date]
Set the date in the system clock of the device.
[Time]
Set the time in the system clock of the device.
[NTP Time Synchronization]
Gets time from server so that it syncs with the time server (NTP) and match the time to the
device.
[Connection Interval]
Select the time interval to connect to the time server.
[Time Server Address]
Set the server name or IP address of the time server.
[Auto Clear]
Specify the time lapsed without any operation until the device resets the settings.
Even when set to [Off], if one minute has elapsed after reading the original but no job starts, the device will
cancel the standby status and begin processing the original.
[Auto Job Release]
Specify the time lapsed until the device cancels the active job and starts the next job if an
error such as a paper jam and running out of paper occurs.
[Auto Print]
Set the time lapsed until the device becomes available to make printing after the last
operation on the control panel (except for [Start]).
[Time Zone]
Set the time difference from GMT between -12 and +12 hours.
[Daylight Savings]
Set the daylight saving time. During the period of daylight saving time you set, the device
moves the clock forward by one hour.
To Next Page
Loading...
Need help?
General
