5-2 ApexPro™ Telemetry 2001989-203C
Configuration
ApexPro Channelized Telemetry System
configuration
Process overview
After completing the physical installation of the equipment, perform the following
procedures:
1. Access the ATS on page 5-2.
2. Configure the ATS on page 5-2.
Access the ATS
The steps for accessing the ATS vary, depending on whether the ATS was shipped
from GE or reimaged from the field.
If you received the ATS from GE, use the IP address information on the stickers
to access the ATS.
If the ATS was reimaged in the field, the software reload procedure returns the
ATS IP address settings and computer name to the following factory default
values:
Configure the ATS
You have two options:
You can restore the system defaults if they were previously saved. See Restore
defaults on page 5-3.
You can configure the standard and specialized functions of the ApexPro
Channelized Telemetry System components. See Configure standard and
specialized functions on page 5-4.
IP Address Subnet Gateway
Network Name PrismServer
IX Address 192.168.1.1 255.255.0.0 192.168.254.254
Unity Address (MC) 192.168.1.2 255.255.0.0 0.0.0.0
Receiver (RX) Address or
OpenNet Address
119.1.1.2 255.0.0.0 0.0.0.0
To Next Page
Loading...
Need help?
General
