5-10 ApexPro™ Telemetry 2001989-203C
Configuration
129A
4. On the Receiver Configuration screen, make the following entries:
a. In the Unit field, type the unit name.
b. In the Number of RX field, type the number of receivers allocated to the
unit.
c. In the Use unassigned field, select Ye s or No to indicate if this unit may or
may not use unallocated receivers.
5. Select Save to store the new configuration entry.
Change a receiver configuration entry
You cannot edit the values for the unit. If you need to change information, you need to
delete the configuration entry and add a new entry with the desired information.
Delete a receiver configuration entry
1. Log onto the Webmin service interface on page 4-7.
2. Select the Configuration tab.
3. Select Receiver Configuration.
109A
4. Select Delete next to the receiver configuration you want to delete.
5. Select OK to confirm that you want to delete the receiver configuration.
Configure the server for Remote Service access
The ATS is capable of remote service using InSite ExC Digital Services. Refer to the
site survey workbook for required configuration information.
To Next Page
Loading...
Need help?
General
