5-18 ApexPro™ Telemetry 2001989-203C
Configuration
Complete installation checkout procedures
Proceed to Installation checkout procedures on page 8-2.
ApexPro FH Telemetry System component
configuration
Process overview
After completing the physical installation of the equipment and you are able to access
the ATS, you can configure the standard and specialized functions of the ApexPro FH
Telemetry System components. Perform the following procedures:
Access the ATS on page 5-2.
Configure the laptop on page 4-3.
Connect the service laptop to the Unity Network IX network on page B-4.
Set the ApexPro FH Telemetry System settings on page 5-18.
Set the ApexPro FH Telemetry System network name and IP address on page 5-
20.
Verify the IP address settings (if required) on page 5-5.
Enable access points for activity on the network on page 5-22.
Configure the server for Remote Service access on page 5-10.
Configure the Transmitter battery status report for viewing and printing on page
5-13
Back up the configuration settings on page 5-15.
Perform installation check on page 5-16.
Complete Installation checkout procedures on page 8-2.
Set the ApexPro FH Telemetry System settings
Perform this procedure to set the following settings:
Language
Mode
Tower name
Unit name, if required
A/C power frequency
Device Master designation
(Optional) Print summary report when patient is discharged
Localization, if required
1. Log onto the Webmin service interface on page 4-7.
2. Select the Configuration tab.
To Next Page
Loading...
Need help?
General
