HP 10500 series User Manual

108
In current MPLS TE applications, the SE style is mainly used for make-before-break. The FF style is rarely
used.
To configure RSVP reservation style:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Configure the resources
reservation style for the tunnel.
mpls te resv-style { ff | se }
Optional.
The default resource reservation
style is SE.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring RSVP state timers
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS view.
mpls N/A
3. Configure the
path/reservation state refresh
interval of the node.
mpls rsvp-te timer refresh
timevalue
Optional.
The default path/reservation state
refresh interval is 30 seconds.
4. Configure the keep multiplier
for PSB and RSB.
mpls rsvp-te keep-multiplier
number
Optional.
The default is 3.
5. Configure the blockade
timeout multiplier.
mpls rsvp-te blockade-multiplier
number
Optional.
The default blockade timeout
multiplier is 4.
Configuring the RSVP refresh mechanism
To enhance reliability of RSVP message transmission, the Message_ID extension mechanism is used to
acknowledge RSVP messages. The Message_ID extension mechanism is also referred to as the reliability
mechanism throughout this document.
After you enable RSVP message acknowledgement on an interface, you can enable retransmission.
To use summary refresh (Srefresh), you must use the Message_ID extension. Only states advertised using
MESSAGE_ID included Path and Resv messages can be refreshed using summary refreshes.
To configure RSVP refreshing mechanism:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view of MPLS TE
link.
interface interface-type interface-number N/A

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English