HP 10500 series User Manual

280
Request time out
Request time out
Request time out
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
0 packet(s) received
100.00% packet loss
Configuring MPLS L3VPNs using IBGP between PE and CE
Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attribute 111:1. VPN 2 uses route target attribute 222:2. Users of different VPNs
cannot access each other.
IBGP is used to exchange VPN routing information between CE and PE.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing information.
Figure 32 Network diagram
Device Interface IP address Device Interface IP address
PE 1 Loop0 1.1.1.9/32 PE 2 Loop0 3.3.3.9/32
Vlan-int11 10.1.1.2/24 Vlan-int12 172.2.1.2/24
Vlan-int13 172.1.1.1/24 Vlan-int11 10.3.1.2/24
Vlan-int12 10.2.1.2/24 Vlan-int13 10.4.1.2/24
CE 1 Loop0 4.4.4.9/32 P Loop0 2.2.2.9/32
Vlan-int11 10.1.1.1/24 Vlan-int12 172.2.1.1/24
CE 2 Loop0 5.5.5.9/32 Vlan-int13 172.1.1.2/24
Vlan-int12 10.2.1.1/24 CE 4 Loop0 7.7.7.9/32
CE 3 Loop0 6.6.6.9/32 Vlan-int13 10.4.1.1/24
Vlan-int11 10.3.1.1/24

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English