HP 10500 series User Manual

205
Ste
p
Command Remarks
6. Enable the filtering by the
VPN target extended
community attributes for the
received routing information.
policy vpn-target
Optional.
Enabled by default.
7. Enable the specified peer or
peers to exchange BGP
routing information of the
BGP-L2VPN address family.
peer { group-name | ip-address }
enable
N/A
Creating and configuring MPLS L2VPN
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an MPLS L2VPN and
enter MPLS L2VPN view.
mpls l2vpn vpn-name [ encapsulation
{ ethernet | vlan } [ control-word |
no-control-word ] ]
You must create an L2VPN
name on the PE for each VPN
where a directly connected
CE resides, and specify an
encapsulation type matching
the AC link type.
3. Configure an RD for the
L2VPN.
route-distinguisher route-distinguisher
Once configured, an RD
cannot be changed, unless
you delete the L2VPN and
then recreate it.
4. Associate the L2VPN with one
or more VPN targets.
vpn-target vpn-target&<1-16> [ both |
export-extcommunity |
import-extcommunity ]
N/A
5. Set the MTU for the L2VPN.
mtu mtu
Optional.
The default MTU is 1500.
The mtu command affects
only parameter negotiation. It
does not affect data
forwarding. HP does not
recommend using this
command
Creating a CE connection
Configuration parameters and guidelines
• id ce-id: Specifies the CE ID of a local CE connected to the PE.
• range ce-range: Specifies the CE range—the maximum number of CEs to which the specified CE
can connect.
You can configure a CE range greater than what is required based on your estimate of future VPN
expansion. This can reduce configuration workload required when CEs are added into the VPN in
future.

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English