HP 10500 series User Manual

66
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS view.
mpls N/A
3. Configure the LSP
establishment triggering
policy.
lsp-trigger [ vpn-instance
vpn-instance-name ] { all | ip-prefix
prefix-name }
Optional.
By default, only host routes with
32-bit masks can trigger
establishment of LSPs.
If the vpn-instance
vpn-instance-name option is
specified, the command configures
an LSP establishment triggering
policy for the specified VPN.
Otherwise, the command
configures an LSP establishment
triggering policy for the public
network routes.
NOTE:
For an LSP to be established, an exactly matching routing entry must exist on the LSR. For example, on an
LSR, to establish an LSP to a loopback address with a 32-bit mask, there must be an exactly matchin
g
hos
t
routing entry on the LSR.
Configuring the label distribution control mode
With the label re-advertisement function enabled, an LSR periodically looks for FECs not assigned with
labels, assigns labels to them if any, and advertises the label-FEC bindings. You can set the label
re-advertisement interval as needed.
To configure the LDP label distribution control mode:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS LDP view.
mpls ldp N/A
3. Specify the label distribution
control mode.
label-distribution { independent |
ordered }
Optional.
The default mode is ordered.
For LDP sessions existing before the
command is configured, you must
reset the LDP sessions for the
specified label distribution control
mode to take effect.
4. Enable label re-advertisement
for DU mode.
du-readvertise
Optional.
By default, label re-advertisement
for DU mode is enabled.
5. Set the interval for label
re-advertisement in DU mode.
du-readvertise timer value
Optional.
The default interval is 30 seconds.

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English