HP 10500 series User Manual

209
Task Command Remarks
Display the MPLS L2VPN PW
information (in IRF mode).
display mpls l2vpn fib pw vpws
[ interface interface-type
interface-number [ service-instance
service-instanceid ] ] [ chassis
chassis-number slot slot-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display information about one or
all PW classes.
display pw-class [ pw-class-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
MPLS L2VPN configuration examples
Configuring a remote CCC connection
Network requirements
The CEs are connected to the PEs through VLAN interfaces.
Create a remote CCC connection between CE 1 and CE 2.
Figure 8 Network diagram
Device Interface IP address Device Interface IP address
CE 1 Vlan-int10 100.1.1.1/24 CE 2 Vlan-int10 100.1.1.2/24
PE 1 Loop0 10.0.0.1/32 P Loop0 10.0.0.2/32
Vlan-int30 10.1.1.1/24 Vlan-int20 10.2.2.2/24
PE 2 Loop0 10.0.0.3/32 Vlan-int30 10.1.1.2/24
Vlan-int20 10.2.2.1/24
Configuration considerations
1. Create remote CCC connections on the PEs. No static LSP is required on the PEs.
2. Configure two static LSPs on the P device for packets to be transferred in both directions.
Configuration procedure
1. On CE 1, configure an IP address forVLAN-interface 10 connected to PE 1.
<Sysname> system-view
[Sysname] sysname CE1

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English