HP 10500 series User Manual

117
Specifying the link metric type for tunnel path calculation
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS view.
mpls N/A
3. Specify the metric type to use
when no metric type is
explicitly configured for a
tunnel.
mpls te path metric-type { igp | te }
Optional.
TE metrics of links are used by
default.
4. Return to system view.
quit N/A
5. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
6. Specify the metric type to use
for path calculation of the
current tunnel.
mpls te path metric-type { igp | te }
Optional.
If you do not specify a metric type
in MPLS TE tunnel interface view,
the one specified in MPLS view
takes effect.
7. Submit current tunnel
configuration.
mpls te commit Optional.
8. Return to system view.
quit N/A
9. Enter interface view of MPLS
TE link.
interface interface-type
interface-number
N/A
10. Assign a TE metric to the link.
mpls te metric value
Optional.
If no TE metric is assigned to the
link, IGP metric is used as the TE
metric by default.
Configuring the traffic flow type of a tunnel
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Configure the traffic flow type
of the TE tunnel.
mpls te vpn-binding { acl
acl-number | vpn-instance
vpn-instance-name }
Optional.
Traffic flow types of TE tunnels are
not restricted by default.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring CR-LSP backup
CR-LSP backup provides end-to-end path protection to protect the entire LSP.

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English