HP 10500 series User Manual

113
Tuning MPLS TE tunnel setup
This section only covers the configuration tasks for tuning MPLS TE tunnel setup.
You must use the configurations described in this section together with a dynamic signaling protocol
(such as RSVP-TE). Before performing the configuration tasks, be aware of each configuration objective
and its impact on your system.
Configuring loop detection
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface view.
interface tunnel tunnel-number N/A
3. Enable the system to perform loop
detection when setting up a tunnel.
mpls te loop-detection Disabled by default.
4. Submit current tunnel configuration.
mpls te commit N/A
Configuring route and label recording
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Enable the system to record
routes or labels when setting
up the tunnel.
• Record routes:
mpls te record-route
• Record routes and labels:
mpls te record-route label
Use either command.
Both route recording and label
recording are disabled by default.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring tunnel setup retry
You can configure the system to attempt setting up a tunnel multiple times until it is established
successfully or until the number of attempts reaches the upper limit.
To configure tunnel setup retry:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Configure maximum number
of tunnel setup retries.
mpls te retry times
Optional.
The default is 10.

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English