To Next Page

To Previous Page

235

RUN <program name>

This command runs the program named, with

execution resuming in the calling program

afterwards. If a particular piece of code is used

repeatedly then this can be used to reduce

memory use by placing the code in a separate

program and calling it from different locations.

See the SETVIEWS command for information on how to link a program to an

aplet when it does not appear on the primary menu. Note that if the name

has spaces in it then it must be enclosed in quotes.

STOP

This command can be used to abort execution

of a program. Control resumes in the HOME

view.

ARC <x-center>;<y-center>;<radius>;<start angle>;<end angle>

This command draws an arc on the

screen. It uses the current values

in the PLOT SETUP view as the

screen coordinates and the

settings in the the MODES view for

angle format. This command is VERY slow.

BOX <x1>;<y1>;<x2>;<y2>

This draws a rectangular box on

the screen using (x1,y1) and

(x2,y2) as the corners. The

coordinates are relative to the

settings in the PLOT SETUP view.

HP 39G Master Guide

Other manuals for HP 39G