Execution modes when using RAID Manager
Manual execution mode
In Manual execution mode, you can manually collect monitoring data and relocate a tier. You can
execute commands to do the following:
1. Start monitoring.
2. Stop monitoring.
3. Perform tier relocation.
The following illustrates tier relocation processing when in Manual execution mode:
Notes on performing monitoring
• You can collect the monitoring data even while performing the relocation.
• After stopping the monitoring, the tier range is automatically calculated.
• The latest available monitoring information, which is collected just before the relocation is
performed, is used for the relocation processing.
• When the relocation is performed, the status of the monitor information must be valid.
Viewing monitor and tier relocation information:
If the raidcom get thp_pool command is executed with the -key opt option specified, the
monitoring information and tier relocation information are displayed. For details about the raidcom
get thp_pool command, see the HP XP7 RAID Manager Reference Guide. Items are displayed
as follows:
• STS
This item displays the operational status of the performance monitor and the tier relocation.
◦ STP: The performance monitor and the tier relocation are stopped.
◦ RLC: The performance monitor is stopped. The tier relocation is operating.
Smart Tiers 91
To Next Page
Loading...
Need help?
General
