HPE FlexNetwork MSR3012 User Manual

127
display poe interface power
Use display poe interface power to display power information for PIs.
Syntax
display poe interface power [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays power information for all PIs.
Examples
# Display power information for GigabitEthernet 1/0/1.
<Sysname> display poe interface power gigabitethernet 1/0/1
Interface Current Peak Max PD Description
(W) (W) (W)
GE1/0/1 15.0 15.3 15.4 Access Point on Room 509 for Peter
# Display power information for all PIs.
<Sysname> display poe interface power
Interface Current Peak Max PD Description
(W) (W) (W)
GE1/0/25 4.4 4.5 4.6 IP Phone in Room 309 for Peter Smith
GE1/0/26 4.4 4.5 15.4 IP Phone in Room 409 for Peter Pan
GE1/0/27 15.0 15.3 15.4 Access Point in Room 509 for Peter
GE1/0/28 0.0 0.0 0.0 IP Phone in Room 609 for Peter John
GE1/0/29 0.0 0.0 0.0 IP Phone in Room 709 for Jack
GE1/0/30 0.0 0.0 0.0 IP Phone in Room 809 for Alien
--- On State Ports: 3; Used: 23.8(W); Remaining: 776.2(W) ---
Table 24 Command output
Field Description
Interface Interface name of a PI.
CurPower Current power of a PI.
PeakPower Peak power of a PI.
MaxPower Maximum power of a PI.
PD Description Type and location description for the PD connected to a PI.
Ports On Number of PIs that are supplying power.
Used Power consumed by all PIs.
Remaining Total remaining power of the system.

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English