HPE FlexNetwork MSR3012 User Manual

449
Views
User view
Predefined user roles
network-admin
Parameters
severity: Specifies a log severity level in the range of 0 to 7.
Usage guidelines
This command enables the device to output logs with a severity level higher than or equal to the
specified level to the current terminal. For example, if you set the severity argument to 6, logs with a
severity value from 0 to 6 are output to the current terminal.
This command takes effect only for the current connection between the terminal and the device. If a
new connection is established, the default is restored.
Examples
# Configure the device to output logs with the debugging level and higher levels to the current
terminal.
<Sysname> terminal logging level 7
terminal monitor
Use terminal monitor to enable the monitoring of logs on the current terminal.
Use undo terminal monitor to disable the monitoring of logs on the current terminal.
Syntax
terminal monitor
undo terminal monitor
Default
Monitoring of logs is enabled on the console and disabled on the monitor terminal.
Views
User view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only for the current connection between the terminal and the device. If a
new connection is established, the default is restored.
Examples
# Enable the monitoring of logs on the current terminal.
<Sysname> terminal monitor
The current terminal is enabled to display logs.

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English

Summary

Ping, tracert, and system debugging commands

ping

Tests reachability of destination IP address and displays ping statistics.

tracert

NQA commands

NQA client commands

Configures NQA client operations, including factors, codec types, and data parameters.

NTP commands

SNTP commands

PoE commands

apply poe-profile

Applies a PoE profile to a power interface (PI).

SNMP commands

display snmp-agent community

Displays SNMPv1 or SNMPv2c community information.

snmp-agent community

Configures an SNMPv1 or SNMPv2c community.

snmp-agent target-host

Configures an SNMP notification target host.

snmp-agent trap enable

Enables SNMP notifications.

RMON commands

display rmon alarm

Displays information about RMON alarm entries.

rmon alarm

Event MIB commands

NETCONF commands

CWMP commands

cwmp enable

Enables CWMP.

EAA commands

action cli

Adds a CLI action to a monitor policy.

rtm cli-policy

Creates a CLI-defined EAA monitor policy and binds it to a Tcl script file.

Process monitoring and maintenance commands

display exception context

Displays context information for process exceptions.

display kernel deadloop

Displays kernel thread deadloop information.

display process

Displays process state information.

monitor kernel starvation enable

Enables kernel thread starvation detection.

Port mirroring commands

mirroring-group

Creates a mirroring group.

Flow mirroring commands

mirror-to

NetStream configuration commands

IPv6 NetStream commands

sFlow commands

Information center commands