355
Sampler commands
Commands and descriptions for centralized devices apply to the following routers:
MSR1002-4/1003-8S.
MSR2003.
MSR2004-24/2004-48.
MSR3012/3024/3044/3064.
MSR954(JH296A/JH297A/JH298A/JH299A/JH373A).
MSR958(JH300A/JH301A).
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
display sampler
Use display sampler to display configuration information for a sampler.
Syntax
Centralized devices in standalone mode:
display sampler [ sampler-name ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display sampler [ sampler-name ] [ slot slot-number ]
Distributed devices in IRF mode:
display sampler [ sampler-name ] [ chassis chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
sampler-name: Specifies a sampler by its name, a case-insensitive string of 1 to 31 characters. If you
do not specify a sampler, this command displays configuration information for all samplers.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays sampler configuration information for the active MPU. (Distributed devices in standalone
mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays sampler configuration information for the master device. (Centralized
devices in IRF mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
sampler configuration information for the global active MPU. (Distributed devices in IRF mode.)
Examples
# Display the configuration information about sampler 256.
<Sysname> display sampler 256
To Next Page
Loading...
Need help?
General
