HPE FlexNetwork MSR3012 User Manual

69
Usage guidelines
If you execute the source interface and source ipv6 commands for an ICMP echo operation
multiple times, the most recent configuration takes effect.
The specified source IPv6 address must be the IPv6 address of a local interface. The local interface
must be up. Otherwise, no probe packets can be sent out.
Examples
# In ICMP echo operation view, specify 1::1 as the source IPv6 address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ipv6 1::1
Related commands
source interface
source port
Use source port to configure the source port number for probe packets.
Use undo source port to restore the default.
Syntax
source port port-number
undo source port
Default
The source port number is not specified.
Views
SNMP/voice operation view
UDP echo operation view
UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
port-number: Specifies the source port number in the range of 1 to 65535.
Examples
# Set the source port number to 8000 for probe packets in the UDP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-echo
[Sysname-nqa-admin-test-udp-echo] source port 8000
statistics hold-time
Use statistics hold-time to set the hold time of statistics groups for an NQA operation.

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English