404
IPv6 NetStream aggregation mode view
Parameters
interface-type interface-number: Specifies a source interface by its type and number for the IPv6
NetStream data export.
Usage guidelines
You can configure different source interfaces in different IPv6 NetStream aggregation mode views.
If no source interface is configured in IPv6 NetStream aggregation mode view, the source interface
in system view applies.
As a best practice, connect the management Ethernet interface to a NetStream server, and configure
the interface as the source interface.
Examples
# In system view, specify GigabitEthernet 1/0/1 as the source interface for IPv6 NetStream traditional
data packets.
<Sysname> system-view
[Sysname] ipv6 netstream export source interface gigabitethernet 1/0/1
# In AS aggregation mode view, specify GigabitEthernet 1/0/2 as the source interface for IPv6
NetStream aggregation data packets.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation as
[Sysname-ns6-aggregation-as] ipv6 netstream export source interface gigabitethernet 1/0/2
Related commands
ipv6 netstream aggregation
ipv6 netstream export v9-template refresh-rate packet
Use ipv6 netstream export v9-template refresh-rate packet to configure the refresh frequency (in
packets) for IPv6 NetStream version 9 templates. The templates are sent after the specified number
of packets are sent.
Use undo ipv6 netstream export v9-template refresh-rate packet to restore the default.
Syntax
ipv6 netstream export v9-template refresh-rate packet packets
undo ipv6 netstream export v9-template refresh-rate packet
Default
Version 9 templates are sent every 20 packets.
Views
System view
Predefined user roles
network-admin
Parameters
packets: Specifies the number of packets that are sent before version 9 templates are sent to
NetStream servers for an update. The value range is 1 to 600.
To Next Page
Loading...
Need help?
General
