HPE FlexNetwork MSR3012 User Manual

270
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe password simple newpsw
Related commands
cwmp cpe username
cwmp cpe provision-code
Use cwmp cpe provision-code to configure the provision code of the CPE.
Use undo cwmp cpe provision-code to restore the default.
Syntax
cwmp cpe provision-code provision-code
undo cwmp cpe provision-code
Default
The provision code is PROVISIONCODE.
Views
CWMP view
Predefined user roles
network-admin
Parameters
provision-code: Specifies a provision code, a string of 1 to 64 characters. The string can contain
uppercase letters, digits, and the full stop (.).
Usage guidelines
The ACS can use the provision code to identify services assigned to each CPE. For correct
configuration deployment, make sure the same provision code is configured on the CPE and the
ACS. For information about the support of your ACS for provision codes, see the ACS
documentation.
The CPE can have only one provision code. If you execute this command multiple times, the most
recent configuration takes effect.
Examples
# Set the provision code to ABC20150714.
<Sysname> system
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe provision-code ABC20150714
cwmp cpe stun enable
Use cwmp cpe stun enable to enable NAT traversal for the connection requests from the ACS to
reach the CPE through a NAT gateway.
Use undo cwmp cpe stun enable to restore the default.
Syntax
cwmp cpe stun enable
undo cwmp cpe stun enable

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English