HPE FlexNetwork MSR3012 User Manual

262
Usage guidelines
You can configure only one password for authentication to the default ACS URL. If you execute this
command multiple times, the most recent configuration takes effect.
For a successful connection, make sure the CPE has the same username and password settings as
the ACS.
You do not need to configure this command if the default ACS URL does not require a password for
authentication.
Examples
# Configure the password used for authentication to the default ACS URL.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp acs default password simple newpsw
Related commands
cwmp acs default url
cwmp acs default username
cwmp acs default url
Use cwmp acs default url to specify a default ACS URL.
Use undo cwmp acs default url to restore the default.
Syntax
cwmp acs default url url
undo cwmp acs default url
Default
No default ACS URL is specified.
Views
CWMP view
Predefined user roles
network-admin
Parameters
url: Specifies the default ACS URL, a string of 8 to 255 characters. The URL must use the
http://host[:port]/path or https://host[:port]/path format.
Usage guidelines
The CPE attempts to connect to the default ACS URL if no ACS URL has been assigned to it through
the cwmp acs url command or DHCP.
You can configure only one default ACS URL. If you execute this command multiple times, the most
recent configuration takes effect.
Examples
# Specify the default ACS URL.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp acs default url http://www.acs.com:80/acs

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English

Summary

Ping, tracert, and system debugging commands

ping

Tests reachability of destination IP address and displays ping statistics.

tracert

NQA commands

NQA client commands

Configures NQA client operations, including factors, codec types, and data parameters.

NTP commands

SNTP commands

PoE commands

apply poe-profile

Applies a PoE profile to a power interface (PI).

SNMP commands

display snmp-agent community

Displays SNMPv1 or SNMPv2c community information.

snmp-agent community

Configures an SNMPv1 or SNMPv2c community.

snmp-agent target-host

Configures an SNMP notification target host.

snmp-agent trap enable

Enables SNMP notifications.

RMON commands

display rmon alarm

Displays information about RMON alarm entries.

rmon alarm

Event MIB commands

NETCONF commands

CWMP commands

cwmp enable

Enables CWMP.

EAA commands

action cli

Adds a CLI action to a monitor policy.

rtm cli-policy

Creates a CLI-defined EAA monitor policy and binds it to a Tcl script file.

Process monitoring and maintenance commands

display exception context

Displays context information for process exceptions.

display kernel deadloop

Displays kernel thread deadloop information.

display process

Displays process state information.

monitor kernel starvation enable

Enables kernel thread starvation detection.

Port mirroring commands

mirroring-group

Creates a mirroring group.

Flow mirroring commands

mirror-to

NetStream configuration commands

IPv6 NetStream commands

sFlow commands

Information center commands