HPE FlexNetwork MSR3012 User Manual

299
Process monitoring and maintenance
commands
Commands and descriptions for centralized devices apply to the following routers:
•
MSR1002-4/1003-8S.
•
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
•
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A).
•
MSR958 (JH300A/JH301A).
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
The display memory, display process, display process cpu, monitor process, and monitor
thread commands display information about both user processes and kernel threads. In these
commands, "process" refers to both user processes and kernel threads.
display exception context
Use display exception context to display context information for process exceptions.
Syntax
Centralized devices in standalone mode:
display exception context [ count value ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display exception context [ count value ] [ slot slot-number [ cpu cpu-number ] ]
Distributed devices in IRF mode:
display exception context [ count value ] [ chassis chassis-number slot slot-number [ cpu
cpu-number ] ]
Views
Any view
Predefined user roles
network-admin
Parameters
count value: Specifies the number of context information entries, in the range of 1 to 20. The default
value is 1.
slot slot-number: Specifies an MPU by its slot number. If you do not specify this option, the
command displays context information for process exceptions on the active MPU. (Distributed
devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its ID. If you do not specify this option, the
command displays context information for process exceptions on the IRF master device.
(Centralized devices in IRF mode.)
chassis chassis-number slot slot-number: Specifies an MPU on an IRF member device. If you do
not specify this option, the command displays context information for process exceptions on the
global active MPU. (Distributed devices in IRF mode.)

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English

Summary

Ping, tracert, and system debugging commands

ping

Tests reachability of destination IP address and displays ping statistics.

tracert

NQA commands

NQA client commands

Configures NQA client operations, including factors, codec types, and data parameters.

NTP commands

SNTP commands

PoE commands

apply poe-profile

Applies a PoE profile to a power interface (PI).

SNMP commands

display snmp-agent community

Displays SNMPv1 or SNMPv2c community information.

snmp-agent community

Configures an SNMPv1 or SNMPv2c community.

snmp-agent target-host

Configures an SNMP notification target host.

snmp-agent trap enable

Enables SNMP notifications.

RMON commands

display rmon alarm

Displays information about RMON alarm entries.

rmon alarm

Event MIB commands

NETCONF commands

CWMP commands

cwmp enable

Enables CWMP.

EAA commands

action cli

Adds a CLI action to a monitor policy.

rtm cli-policy

Creates a CLI-defined EAA monitor policy and binds it to a Tcl script file.

Process monitoring and maintenance commands

display exception context

Displays context information for process exceptions.

display kernel deadloop

Displays kernel thread deadloop information.

display process

Displays process state information.

monitor kernel starvation enable

Enables kernel thread starvation detection.

Port mirroring commands

mirroring-group

Creates a mirroring group.

Flow mirroring commands

mirror-to

NetStream configuration commands

IPv6 NetStream commands

sFlow commands

Information center commands