61
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction 2 checked-element probe-duration
threshold-type accumulate 10 threshold-value 50 5 action-type trap-only
# Create reaction entry 3 for monitoring the probe duration time of ICMP echo operation, and set the
upper limit to 50 milliseconds and the lower limit to 5 milliseconds. Before the NQA operation starts,
the initial state of the reaction entry is invalid. After the operation, the consecutive probe duration is
checked against the threshold range. If the total number of consecutive threshold violations reaches
or exceeds 10, the state of the entry is set to over-threshold. If it is below the lower threshold, the
state of the entry is set to below-threshold. Once the state of the reaction entry changes, a trap
message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction 3 checked-element probe-duration
threshold-type consecutive 10 threshold-value 50 5 action-type trap-only
reaction checked-element probe-fail (for trap)
Use reaction checked-element probe-fail to configure a reaction entry for monitoring the probe
failures of the operation.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element probe-fail threshold-type { accumulate
accumulate-occurrences | consecutive consecutive-occurrences } [ action-type { none |
trap-only } ]
undo reaction item-number
Default
No reaction entries for monitoring probe failures exist.
Views
DHCP/DLSw/DNS/FTP/HTTP/SNMP/TCP operation view
ICMP/UDP echo operation view
Predefined user roles
network-admin
Parameters
item-number: Assigns an ID to the reaction entry, in the range of 1 to 10.
threshold-type: Specifies a threshold type.
accumulate accumulate-occurrences: Checks the total number of probe failures. The value range is
1 to 15.
consecutive consecutive-occurrences: Checks the maximum number of consecutive probe failures.
The value range is 1 to 16.
action-type: Specifies what action to be triggered. The default action is none.
none: Specifies the action of displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS. This keyword is not available for the DNS operation.
To Next Page
Loading...
Need help?
General
