HPE FlexNetwork MSR3012 User Manual

403
# In AS aggregation mode view, specify 40::1 as the IP address of the destination host and UDP port
6000 as the export destination port number.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation as
[Sysname-ns6-aggregation-as] ipv6 netstream export host 40::1 6000
Related commands
ipv6 netstream aggregation
ipv6 netstream export source
ipv6 netstream export rate
Use ipv6 netstream export rate to limit the IPv6 NetStream data export rate.
Use undo ipv6 netstream export rate to restore the default.
Syntax
ipv6 netstream export rate rate
undo ipv6 netstream export rate
Default
The export rate of IPv6 NetStream data is not limited.
Views
System view
Predefined user roles
network-admin
Parameters
rate: Specifies the maximum number of packets to be exported per second. The value range is 1 to
1000.
Examples
# Allow a maximum of 10 packets to be exported per second.
<Sysname> system-view
[Sysname] ipv6 netstream export rate 10
ipv6 netstream export source
Use ipv6 netstream export source to specify the source interface for data packets sent to
NetStream servers. The IPv6 address of the interface is used as the source IPv6 address of the data
packets.
Use undo ipv6 netstream export source to restore the default.
Syntax
ipv6 netstream export source interface interface-type interface-number
undo ipv6 netstream export source
Default
The packets take the primary IPv6 address of the output interface as the source IPv6 address.
Views
System view

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English